12
English
Customizing default volumes
1 Install the portafilter with tamped ground coffee inside the brewing head.
2 Press and hold the button of the drink you want to customize. After three seconds, the machine
enters the customization mode and emits a beep.
3 Stop holding the buttons when the cup contains the desired volume. The setting is complete
when you hear one beep from the machine.
4 After you have programmed the volume for a drink, the machine will dispense this new volume
each time you select the drink again.
Press and hold the Americano button to extract the desired coffee volume. Release to set the
new coffee volume. Repeat for water volume adjustment.
The minimum Espresso and Double Espresso volumes are 20 ml and 40 ml, respectively.
The maximum Espresso and Double Espresso volumes are 70 ml and 120 ml, respectively.
For Americano, the minimum and maximum volume of coffee is 20 ml and 70 ml respectively.
The minimum and maximum volume of hot water is 50 ml and 200 ml respectively.
Customizing coffee temperature
It is possible to adjust the coffee extraction temperature. You can choose from three settings: warm
coffee, medium hot coffee, hot coffee. At a higher coffee extraction temperature, the bitterness of
the coffee will increase and the acidity will decrease. At a lower coffee extraction temperature, the
bitterness of the coffee will decrease and the acidity will increase.
1 Turn off the the machine.
2 Press and hold the On/Off button and the Espresso button for three seconds. The machine will
emit a beep sound.
3 Press one of the buttons below to adjust the coffee extracting temperature setting to your
preferred level.
-
To adjust the setting to warm coffee, press the Espresso button
-
To adjust the setting to medium hot coffee, press the Double Espresso button.
-
To adjust the setting to hot coffee, press the Americano button.
Once the right temperature of coffee is selected, press the On/Off button to confirm.
If you do not switch off the machine yourself, it will switch off automatically after 30 minutes.
Setting water hardness
1 Turn off the machine.
2 Press the On/Off button and the Americano button at the same time for three seconds. The
Descale and the On/Off button light will blink.
The default is hard water, so the Americano button light will be on.
-
To adjust the setting to medium water quality, press the Double Espresso button.
-
To adjust the setting to soft water quality, press the Espresso button.
Once the right hardness of the water is selected, press the On/Off button to confirm.
To Next Page
Loading...
