— 24 —
O
PERATING
O
THER
M
ANUFACTURERS
’ TV
You can use this remote control to
operate your TV, not only PHILIPS TV
but also other manufacturers’ TVs
listed below.
You first need to set the manufacturer’s
code.
Note:
Though this remote control can operate most
of the PHILIPS TVs as well as many other
manufacturers’, some of the TVs will not
operate or some functions available on the
TVs will not work with this remote control.
1Set Code
1 Press and hold TV.
2 Press two Number buttons for the
manufacturer’s code number of your
TV, referring to the table to the right.
• For example, for 02, press 0 then 2.
3 Press STOP 7, then release TV.
• The remote control can now operate
the TV of the selected code.
2Confirm Setting
Press POWER, pointing the remote
control at the TV.
If the TV turns on or off, your setting is
completed.
If not, repeat steps above, using another
code.
After replacing the batteries
You need to reset the manufacturer’s code
again.
TV Manufacturers’ Codes
PHILIPS 01, 02, 03
EMERSON 14
GOLDSTAR 04
GRUNDIG 24, 25
HITACHI 12
JVC 05
MITSUBISHI 13, 26
PANASONIC 07, 17, 19, 20
RCA 10
SAMSUNG 18
SANYO 11
SHARP 16
SONY 09
THOMSON 21, 22, 23
TOSHIBA 08
ZENITH 06, 15
VR788/888-55 NEW 6/3/99, 11:52 PM24
To Next Page
Loading...
