GW PL ETH/…BUS
20/46
PHOENIX CONTACT 3433_en_C
If using static IP addresses, click the “Specify a static IP address” option button. Enter
the desired information in the fields provided.
Click the “Apply Changes” button to save the configuration.
4.2.3 Diagnostics
Click the “Diagnostics” tab to view the expansion modules that are connected to the GW PL
ETH/…BUS head station.
Figure 4-5 “Diagnostics” page
The “Diagnostics” page provides the slave ID designation for any connected expansion
modules. Click the “Live list” link under each module to view information about the HART
devices connected to that module.
4.2.3.1 Live list
The “Live list” page displays information about all devices connected to the selected GW PL
ETH/…BUS expansion module.
Figure 4-6 “Live list” page
Each device must have a different IP address. When the IP address is changed from the
factory default, you must know the address to log back in to the web server. If DHCP
addressing is used, additional software may be necessary to determine the IP address
based on the MAC address of the device.
To Next Page
Loading...
Need help?
General