Phoenix Contact INTERBUS series - Connecting Supply Line of Installation Local Bus

onlinecomponents.com
IBSL SYS PRO UM E
1-30 6057AC01
• Wire the connector (Figure 1-25, C). For the pin assignment please
refer to the following table.
Please note that for modules to which an installation local bus is
connected, pins 1 and 2 of the installation local bus interface must be
jumpered. If an installation local bus is not connected this jumper is not
required.
• Insert the wired connector into the module (Figure 1-25, D).
Connecting the Supply Line of the Installation Local Bus
The installation local bus supply is connected with COMBICON
connectors.
• Install the cable as it is described on page 1-29.
• Wire the connector (Figure 1-25, E). For the pin assignment please
refer to the following table.
Table 1-3 Pin assignment of the installation local bus
Pin Signal
1LBST jumper
2LBST jumper
3 DT+ (+ installation local bus forward)
4 DT- (- installation local bus forward)
5 DR+ (+ installation local bus return)
6 DR- (- installation local bus return)
Table 1-4 Pin assignment of the supply line
Pin Signal
1+U
S
2-U
S