onlinecomponents.com
INTERBUS Loop
6057AC01 1-33
1.8.6 Connecting the Installation Local Bus (Modules)
The connecting cable types depend on the module type.
– For modules that have only inputs you need a two-wire installation local
bus cable (Figure 1-28, A1).
– For modules with outputs you need in addition a three-wire cable for the
actuator supply (Figure 1-28, A2).
Figure 1-28 Assembling the connecting cable
1 Green cap nut 5 Black cap nut
2 Grommet 6 Grommet
3 2-pos. splice ring 7 3-pos. splice ring
4 Compression ring
A 1
1
4
2
3
( P G 1 1 )
I N
O U T
6 0 5 7 A 0 2 8
B
C
D
A 2
5
6
7
( P G 1 3 , 5 )
1
2
3
To Next Page
Loading...
