onlinecomponents.com
IBSL SYS PRO UM E
1-32 6057AC01
To avoid mixing up IN and OUT connections of the installation local bus,
the splice ring keying for the incoming installation local bus (IN) is circular
and the splice ring keying for the outgoing installation local bus (OUT) is
square.
The splice ring openings are marked 1 and 2.
• Cut off the protruding wire ends (Figure 1-26, D).
Ensure that the wire ends are flush with the splice ring; they must
neither protrude nor be too short.
Figure 1-27 Inserting QUICKON
• Attach the assembled cable to the appropriate connector on the
module.
• Turn the assembled cable until the coding tabs fit exactly into the
guideways.
• Tighten the threaded joint by turning the cap nut. The insulation is cut
open and the electrical contact is established (QUICKON connection
method).
Table 1-5 Pin assignment of the splice ring
Pin Signal
1+
2-
A
B
5 7 9 6 0 4 0 8
To Next Page
Loading...
