Phoenix Auto Equipment
-Address: 2711 East Craig Road Ste #E, North Las Vegas, NV, 89030 United States
- Website: https://www.phoenixautoequipment.com
- Phone: 7025802883
6 / 22
2. Product Specification
a. Equipment Specification
Rim clamping inside 13"-26"
Rim clamping outside 15"-28"
Maximum Tire Diameter 43"
Maximum wheel Width 15"
Includes bead blast air blast
Includes assist arm
ALU front foot pedal valve ,ALU air distributor valve last longer
than the regular plastic valve
ALU canister of the bead breaker cylinder avoid getting rusty
and more powerful for braking the bead
Blast Inflation
Bead Break force 5700 lbs.
Operating pressure 120 psi
Voltage 110v, 1.5HP motor
Includes 4 clamp protect covers
Plastic mount/demount Head
b. Equipment Presetting and Special Requirements
Air pressure presetting: The machine could run normally when
the air pressure is 8-10bar. The air pressure should not less
than 8 bars.
Mounting tool presetting: The mounting tool is already
calibrated according to a standard 13” rim. For a bigger or
smaller rim, you have to lose bolts fixing on the mounting tool
and at the bottom of the hexagonal bar. Adjust the mounting
tool to a suitable position.
Oil mass presetting: The oil mass in the oil segregator is already
well prepared before it leaves the factory. If the fluid rate is too
To Next Page
Loading...
Need help?
General