Phoenix Auto Equipment
-Address: 2711 East Craig Road Ste #E, North Las Vegas, NV, 89030 United States
- Website: https://www.phoenixautoequipment.com
- Phone: 7025802883
16 / 22
Before carrying out any operation, deflate the tire and take off all
the wheel balancing weights. (Fig. 20)
Position the wheel against the rubber stops on the right side of the
tire changer
Position the bead breaker blade against the tire bead at a distance
of about 1 cm from the rim. Press down the bead breaker control
pedal (3) to activate the bead breaker and release it when the blade
has reached the end of its travel or in any case when the bead is
broken. Before use, spread the grease onto the tire bead. (Fig. 21)
Rotate the tire slightly and repeat the operation around the entire
circumference of the rim and from both sides until the bead is
completely detached from the rim.
b. Removing the Tire
Clean the turntable.
Spread the grease onto the tire bead.
Determine the mounting side of the wheel. The mounting side is
the narrow side of tire rim.
Place tire on table top with mounting side up.
Lock the rim on the turntable.
(Fig. 20) (Fig. 21)
To Next Page
Loading...
Need help?
General