Step 8: Adjust the Building Plate
Once the building plate has touched the LCD screen, make sure to stabilize the building
plate by holding both the upper and lower platforms with your hands. After calibration,
slightly tug on the paper to make sure that the friction force between all four corners are the
same.
Step 9: Tighten the Smaller Screws on the Building Plate
Rotate the four smaller screws at a smaller angle until they touch the lower platform.
Then use one hand to rotate the screws, while another tugs on the paper.
*Note:
Do not tighten the screws too tight or else the Z-axis Calibration may become inaccurate.
To Next Page
Loading...
