Step 6: Apply Pressure on the Building Plate
Once the building plate has touched down, apply pressure and press down firmly on the
sides of the building plate. Pull on the piece of paper to make sure the building plate is laying
tight against it.
*Note: Make sure your device makes a beeping sound before moving onto the next step.
Step 7: Set all Screws in a Cross Pattern Order
Once you have successfully adjusted the building plate, set all four screws on the sides of
the building plate in a clockwise direction while pressing down on the building plate with the
other hand, in a cross pattern order, e.g., top-right, lower-left, top-left, and lower-right. Make
sure to not tighten the screws completely.
To Next Page
Loading...
