1.After the machine calibration is completed, the resin can be introduced into the
tank after the resin tank is installed back.
2.Shake evenly before pouring to avoid poor molding
3. If the resin is already in the tank, please mix and print again.
4. Please do not pour the resin over 1/2 of the height of the tank.
●UPLOAD FILES
USB connection method: After using the computer to process the 3D image file.
Transfer the .phz file (Phrozen software) or zip file (red rabbit slice and save the
zip file) to the USB, and the machine is directly operated through the touch panel
in front of the machine. Insert the USB plug into the port on the back of the
machine. After inserting, the touch panel on the front of the machine can directly
read the file on the USB and operate the machine with the touch panel
To Next Page
Loading...
