The user of the login system is divided into 2 levels, respectively, with the
command level, the access level of the user can use the access level commands,
privileged users can use all the commands.
3.3 Command line view
Each command line view is based on different configuration requirements, there
are connections and differences between them. For example, the OLT establ ish
the connection immediatelyr entering the view after enter a user ID and password,
it can only view the running status and statistics The simple function, you can type
config command to enter the config view , you can type in different commands to
enter the corresponding view.
Command line provides the following seven views: view, config, ge port, pon port,
onu, multicast, vlan.
Into the specific operating rules of the view:
Enter / exit the view view: with the OLT connection, enter the password, you
can enter the view view to see the system running state, the default password
is admin; input exit to disconnect the connection with the OLT.
Login:admin
Password: * * * *
Host#exit
Entry / exit config view: typing configure on enable view, you can enter to
config view global configuration; type exit or end retreated to the view.
Host#configure
Host (config) # exit
Host#
Entry / exit ge port view: in the config view input interface ethernet
(slotid/portid:1/<1-4>) can enter to uplink view Gigabit uplink port
configuration; type exit retreated to config view, input end retreated to the
view.
Entry / Exit pon view: in config view input int pon slotid / portid (slotid / portid:
1/<1-4>) to proceed to the next pon view a PON port configuration; enter the
To Next Page