configure the ONT manually that has been registered or required for pre
configuration for the registration.
Automatic authorization means that when the ONT is successfully registered to
OLT, the system automatically completes the authorization operation without
human operation.
After authorization, the ONT data will be written to the software and hardware
related tables.
ONT's service template mainly has the DBA template and QINQ template.
DBA template is a service bandwidth template, which is based on the ONT
configuration of a class template.
The QINQ template is a service template for FHL104C, which defines the VLAN,
priorities, and ETH types of service flows.
4.2 PON configuration
4.2.1 Global parameter configuration
Authorization mode configuration:
In config mode, enter the command:
authorize-mode can operate authorization mode switch. The default authorization
mode is MAC address. If you need to change the authorization mode to Hybird
(that is, MAC address +LOID), enter the following command:
Host (config) # authorize-mode hybrid
note: authorization model and authorization policy interdependence. When the
authorization strategy for automatic license, you cannot modify the licensing
model.
Authorization policy configuration:
The system default authorization policy is "automatic authorization", such as the
need to modify the authorization policy for manual authorization, can enter the
command:
Host (config) #authorize- policy manual
Note: the configuration of the automatic authorization policy is dependent on the
authorization mode. Only when the MAC address is configured for automatic
To Next Page