Host(qinq-profile-10)#profile-name qinq
Host(qinq-profile-10)#rule 1 add-svlan 200 cvlan 100 ------inlayer vlan
100,outlayer vlan 200
Host(config)# interface pon 1/1
Host(config-pon-1/1)#bind qinq-profile qinq -------PON port bind QINQ template
When the QINQ template rule is created, it can be added to the outer VLAN.
Such as the first layer after the VLAN switch, and then add the outer VLAN:
Host(qinq-profile-20)#rule 1 translate cvlan 5 to 10 add-svlan 100
For a specific range of inner VLAN, do add outer VLAN operation:
Host(qinq-profile-20)#rule 2 add-svlan 400 cvlan-range 40 50
When you add an outer VLAN, you can make a Ethernet Type and a priority of the
outer VLAN, which can be copied from the inner VLAN, and also can be specified
manually:
Host(qinq-profile-20)#rule 3 add-svlan 300 copy cvlan-cos ethertype
0x8200 cvlan-cos 7 cvlan-range 20 30
Customers need to be based on the actual service network planning, to configure
the appropriate QINQ template.
Generally speaking, the VLAN at network side is limited, service planning is
generally a type of service planning a VLAN. In order to simplify the configuration
and for a small access network, VLAN user side can be consistent with the
network side, do not need to configure QinQ double VLAN. Such simple
configuration, easy maintenance. The side of the user can use the VLAN range
1-4095, user side of VLAN can be identical to the network side, can also be
different.For the user side of VLAN at network side, QinQ configuration templates
are as follows:
Host(config)# qinq-profile 30
Host(qinq-profile-30)#profile-name3service
Host(qinq-profile-30)# rule 1 translate cvlan 10 to 10 -------user VLAN
To Next Page