PIAGGIO X9 Evolution 500 - Page 131

- Loosen the magneto flywheel fastening nut.
- Remove the special tool and the fastening nut.
- Remove the washer.
- Insert the nut again so as to slightly uncover the
shaft and free the space that was occupied by the
washer.
CAUTION
THIS OPERATION IS REQUIRED AS THE FLYWHEEL IS
STRONGLY LOCKED; THE CONE DETACHMENT MAY
THEREFORE CAUSE THE ROTOR SLIPPAGE, WITH THE
CONSEQUENT BREAKAGE OF THE MAGNETS.
- Insert the special removing tool.
- Using a 27-mm wrench and a 19-mm bushing,
release the flywheel.
Specific tooling
020467Y Flywheel extractor
X9 Evolution 500 Engine
ENG - 131