1
Contents
Introduction 2
Welcome 2
Evo panel layouts 3
Installation 5
Setting up the signal heads 5
Preparing for operation 6
Setting slaves 6
...Vehicle 7
...Pedestrian 7
Setting the master 8
...Switching on 8
...Vehicle phases 9
...Pedestrian 10
...Starting operation 11
Performing a test start 11
Pedestrian only installations 12
Linking phases 12
Radio channels 13
When mixing Multi-channel and
standard controllers 13
Using the scan option 13
Discovering the radio channel
during operation 13
Transmitter power 14
Reducing transmitter power to
avoid interference 14
Operation 15
Making adjustments 15
Operation modes 16
Communication failures 16
Calling ‘hold all red’ 17
Checking battery charge levels 18
Resetting the system 18
Decommissioning the system 19
Incidents during operation 20
Error indications 21
Troubleshooting 23
Warranty and Environmental information 24
Disclaimers 24
End of life disposal 25
Appendix 1: Phase set up examples 26
Basic shuttle working 27
Standalone pedestrian crossing 28
Standalone pedestrian crossing with
two vehicle heads per approach 29
Shuttle working plus pedestrian 30
Combined carriageway plus
pedestrian crossings 31
Two-way crossroad plus
pedestrian crossings 32
Four-way crossroad plus
pedestrian crossings 33
Five-way staggered junction
plus pedestrian crossings 34
Fast carriageway with side road 35
To Next Page
Loading...
Need help?
General
