PIKO SmartControl light User Manual

System
light
12
To simplify the selection of a locomotive, you can assign a symbol (in our example the symbol of an
ICE railcar) and a name (in our example “PIKO ICE Test”) to each loco address. Once assigned, this
data set is saved on the PIKO SmartController
light
. For every new selection of a locomotive, you can
choose the loco by its name on the list.
We show you how to create loco datasets in chapter 9.1 “change loco data”.
If you want to control a vehicle with the PIKO SmartController
light
, you have to select it by its decoder
address or the assigned name.
While in loco mode, you can start the selection of a locomotive by pressing on [lok] or [↩]. By turning
the encoder wheel, you can select a locomotive out of the loco database (if there are any available
datasets). When you found the desired locomotive, you can select it by again pressing [lok] or [↩].

PIKO SmartControl light Specifications

General

Brand	PIKO
Model	SmartControl light
Category	Controller
Language	English