23
• By pressing [4] and using the [▲] or [▼] key, you can select between the “switch function”
and the “pusher function”. Conrm your choice with [↩].
• Leave the sub-menu by pressing [0].
You can change the data format by pressing [5] and then use the [▲] and [▼] key to select. Conrm
your selection by pressing [↩]. You can select between 14, 28 and 128 DCC speed levels.
Speed levels: The speed of every locomotive is not controlled linearly but through speed levels. The
higher the number of speed levels the more sensitive you can control the vehicle between a halt and its
top speed.
If you want to save the data set, press the [↩] key to leave the menu.
If you want to delete a selected loco data set, press the [stop/delete] key.
By pressing [lok] or [mode] you can leave the menu without saving the changes to the loco data.
10. Special function symbols
Hereafter you nd a short overview of the before mentioned special function symbols and their
meanings (non-binding). Overall, there are more than 160 special function symbols available.
Preset: no Symbol
Light
Driver cabin - Front
Driver cabin - Rear
Move up/down
Move right/left
Hook Up
Hook Down
Turn right
Turn left
Telex coupling
Uncoupler
Shunting gear
Interior Light
High beam
Tail Light
Tail Light
Light front and back
Interior Light
Driver cabin lighting
Doors Opening
Power Pickup
Start/Brake Inertia
Sound
Mute Sound
Horn
Bell
Whistle
Conductor Whistle
Brake Squeal
Diesel motor
Smoke generator
Magnet
I. Further features
To Next Page
Loading...
Need help?
General
