System
light
22
By pressing [2] you can change the loco symbol. The symbol can be selected out of a list by using the
[▲] and [▼] keys and has to be conrmed with the [↩].
By pressing [3] you can change the loco name.
• The position of the cursor can be changed by turning the encoder wheel.
• Then, please press sown the encoder wheel.
• Now you can select the rst digit by turning the encoder wheel. To enter a number, you can
use the respective number keys. The [stop/delete] key generates blank space.
• If you press the encoder wheel again, the selected number or letter is accepted and you can
turn to the next digit.
• When all digits of the loco name are entered, the name can be conrmed and saved by
pressing [↩].
By pressing [4] you can switch to the “change func. icon” menu.
Here you can assign symbols to every loco function from 0 to 24. Additionally, you can decide whether
to use the respective functions as a switch or pusher function. (switching characteristic).
Switch function: With every keystroke the function switches between “on” and “off”.
Pusher function: If you press the key and hold it, the function is turned on. By letting go of the key, the
function turns off.
• At rst press [1] to decide whether
o you want to set the conguration of the symbols to “UNI”. Here, all spe-cial functions are
displayed by standard symbols (a circle) and the “switch function” is activated (function
stays “on” until the key is pressed again)
o you want to set the conguration of the symbols to “MULTI”. Here, you can assign an
individual symbol to each function and you can decide whether to use the “switch function”
or the “pusher function”.
On the following picture you can see an example where an individual symbol and the “switch function”
is assigned to F1.
• With the [▲] and [▼] keys you can choose between one of the two possibili-ties and conrm it
with the [↩] key.
• If “MULTI“ is activated you can press [2] and enter the function number (0 - 24) you want to
change. The number can be entered with the number keys and conrmed by pressing [↩].
• By pressing [3] the function symbol can be changed. You can select the sym-bol with the [▲]
and [▼] keys out of the symbol list and conrm it by pressing [↩].
To Next Page
Loading...
Need help?
General
