IM_208.CCF.20170508-EN
18
Setup and operating
2.2 First steps
Check the device and the cable before every use. A
damaged device may not be used.
Do not take the device in operation in explosive
surroundings! Follow the safety instructions to this 1.5 The use at
ceratin places and environmental conditions.
Make sure that the device is switched off at the grip
before you put this together with the Gimbal. Otherwise the device can
be damaged by short circuit.
Before the first use, charge the accumulator that the device
works optimally.
1. Check, that the device is switched off.
1
2. The grip is screwed together with the Gimbal.
2
To Next Page
Loading...
