Pilz PZE x4p - Operation and Faults; Faults and Interference

PZEX4P
OperatingManualPZEX4P
1003201EN08
8
Operation
Statusindicators
CH.1
Safetycontactsofchannel1areclosed.
CH.2
Safetycontactsofchannel2areclosed.
Faults–Interference
Byclosingorinterruptingtheinputcircuityoucancheckwhethertheunitswitchesonoroff
correctly.
Forsafetyreasons,theunitcannotbestartedifthefollowingfaultsarepresent:
}
Contactmalfunction:Asthecontactblockisconnectedtoabaseunit,
reactivationwillnotbepossibleifthecontactshaveweldedaftertheinputcircuithas
opened.
}
Opencircuit,shortcircuitorearthfault(e.g.intheinputcircuit)
Dimensionsinmm
*withspringloadedterminals
121 (4.76")
22,5
(0.88")
* 101 (3.98")
94 (3.70")