Why can’t MIDI sequencer be synchronized with my Pioneer DJM-700?
If a MIDI sequencer can’t be synchronized with your Pioneer Music Mixer: * Ensure the MIDI sequencer’s sync mode is set to “slave”. * Note that MIDI sequencers that do not support MIDI timing clock cannot be synchronized.
Power| power requirements | AC 120V, 60Hz |
|---|---|
| power consumption | 34W |
Audio Performance| frequency response | 20Hz - 20kHz |
|---|---|
| signal-to-noise ratio | 104dB (LINE) |
| total harmonic distortion | 0.005% or less |
Connectivity| input terminal - CD/LINE | 5 (RCA) |
|---|---|
| input terminal - PHONO | 3 (RCA) |
| input terminal - MIC | 2 (XLR x1, 1/4” PHONE x1) |
| output terminal - MASTER OUT | 2 (RCA x1, XLR x1) |
| output terminal - BOOTH OUT | 1 (RCA) |
| output terminal - HEADPHONE MONITOR OUT | 1 (TOP PANEL 1/4” PHONE x1) |
| output terminal - REC OUT | 1 (RCA) |
| output terminal - DIGITAL OUT | 1 (COAXIAL) |
| other terminals - SEND | 1 (1/4” PHONE) |
| other terminals - RETURN | 1 (1/4” PHONE) |
| other terminals - MIDI OUT | 1 (5P DIN) |
| other terminals - CONTROL OUT | 2 (3.5 MINI JACK) |
Audio Processing| a/d, d/a converter | 24-bit |
|---|---|
| sampling rate | 96kHz |
| head room | 19dB |
Weight and Dimensions| weight | 14.5 lbs |
|---|---|
| width | 12.6 inches |
| depth | 14.9 inches |
| height | 4.25 inches |
To Next Page
