Pioneer MEP-7000 User Manual

CONNECTIONS
19
En
English
MANIPULATOR STYLE CONNECTIONS
These connections should be used when you wish to operate the accessory DJS or other DJ software without connecting the drive unit.
Use the accessory USB auxiliary power cable and the normal USB cable to connect the control unit to the computer (connect the USB
auxiliary p ower cable first).
NOTE
• When making manipulator style connections, do not connect the drive unit, since it will not function correctly.
• Do not connect anything to the 5 V connector other than the accessory USB auxiliary power cable.
• Always use the accessory USB auxiliary power cable and USB cable only.
• Always connect the accessory USB auxiliary power cable and USB cable to one and the same computer.
• Do not connect this unit to a computer through a USB hub.
• Do not connect this unit to a computer through a CardBus-supported USB interface card.
REMOTE
CONTROL
PC
MONITOR OUT
5V
Do not connect until you have installed the required driver
in your computer. See “ABOUT THE DRIVER PROGRAM”
(P.51).
Control unit
Accessory USB cable
Accessory USB auxiliary
power cable.
Computer
Audio interface (sold separately)
Audio cable
Mixer
MEP-7000_KU_EN.book 19 ページ ２００９年２月１２日 木曜日 午後３時１５分

Pioneer MEP-7000 Specifications

General

Frequency range	4 - 20000 Hz
Channels quantity	- channels
Digital sound processing	- bit
Total Harmonic Distortion (THD)	0.006 %
Dimensions (WxDxH)	483 x 325 x 91 mm
Power consumption (typical)	33 W

Weight and Dimensions

Weight	6100 g