Pioneer PDP-436SXE

48
En
Useful Adjustment Settings
11
Changing the brightness at both sides
of the screen (Side Mask)
With the 4:3, FULL 14:9, or CINEMA 14:9 screen size, you can
change the brightness of the grey side masks that appear at
both sides of the screen.
1 Press HOME MENU.
2 Select “Option” ( / then ENTER).
3 Select “Side Mask” ( / then ENTER).
4 Select the desired parameter ( / then ENTER).
5 Press HOME MENU to exit the menu.
NOTE
• If you select “Auto”, the selection for “Drive Mode” (page 46)
becomes ineffective.
Sleep Timer
When the selected time elapses, the Sleep Timer automatically
places the system into the standby mode.
1 Press HOME MENU.
2 Select “Sleep Timer” ( / then ENTER).
3 Select the desired time ( / then ENTER).
• You can select from among “Off” (cancel), “30 min”, “60
min”, “90 min”, and “120 min”.
4 Press HOME MENU to exit the menu.
NOTE
• Five minutes before the selected time elapses, the remaining
time appears every minute.
• To check the remaining time, perform steps 1 and 2. After
checking the time, press HOME MENU to restore the
previous display.
• The SLEEP indicator on the front of the Plasma Display lights
up in orange when the Sleep Timer is set.
Using a password
The Plasma Display System provides the Channel lock function
and Child lock function for preventing children from watching
inappropriate programmes. You need to enter a password
when watching programmes with “Block” specified. Before the
system is shipped, “1234” is preset as the factory-default
password. You can however, change the password as you
want.
When using the Home menu you select “Auto Installation”,
“Analogue TV Setup”,“DTV Setup”, or “Password”, a screen
prompting password entry appears to prevent others from
changing the programme settings at their choices.
Entering a password
In a case where you select a channel blocked with Channel
lock function or Child lock function or if password entry is
requested when attempting to open the menu, enter a
password correctly.
1 Enter a correct 4-digit password using buttons 0 – 9.
NOTE
• If you fail password entry three times, “Invalid password.”
appears, and the menu is closed. In order to display the
password entry screen again to unlock the password, select
the blocked channel or open the menu again.
• If the password entry screen disappears before entry, you
may recall it by pressing ENTER.
Item Description
Fixed
(factory default)
Always sets the same brightness for the grey
side masks.
Auto Adjusts the brightness of the grey side masks
according to the brightness of images.
Side Mask
Fixed
Auto
Please Input Your Password.
PDP-436SXE.book Page 48 Tuesday, November 8, 2005 10:04 AM