T
Command Operation Remarks
M
MRG AD MAIN R GAIN
MRO AD MAIN R OFFSET
MGG AD MAIN G GAIN
MGO AD MAIN G OFFSET
MBG AD MAIN B GAIN
MBO AD MAIN B OFFSET
P
PBH Panel W/B B-HIGH adjustment
PBL Panel W/B B-LOW adjustment
PGH Panel W/B G-HIGH adjustment
PGL Panel W/B G-LOW adjustment
POF Turning the power OFF
PRH Panel W/B R-HIGH adjustment
PRL Panel W/B R-LOW adjustment
R
RYG RY GAIN
RSL Adjustment of side mask R
S
S1G IC1 SUB GAIN
S1O IC1 SUB OFFSET
SBG AD SUB B GAIN
SBO AD SUB B OFFSET
SFI Initialization of the full mask table
SGG AD SUB G GAIN
SGO AD SUB G OFFSET
SRG AD SUB R GAIN
SRO AD SUB R OFFSET
TSY Enabling the TRAP switch The command is effective even during Standby mode.
U
UP* Increasing the adjustment value by * *: 1-9, 0 (0 means 10), or F (making the adjustment value the maximum)
UAJ Resetting all data in the DIGITAL Assy to those of a new service part
V
VOF Offset voltage adjustment
VSU SUS voltage adjustment
X
XD1 D1 trailing-edge pulse of X-SUS
XD2 D2 trailing-edge pulse of X-SUS
XU1 U1 leading-edge pulse of X-SUS
XU2 U2 leading-edge pulse of X-SUS
Y
YD1 D1 trailing-edge pulse of Y-SUS
YD2 D2 trailing-edge pulse of Y-SUS
YD3 D3 trailing-edge pulse of Y-SUS
YD4 D4 trailing-edge pulse of Y-SUS
YU1 U1 leading-edge pulse of Y-SUS
YU2 U2 leading-edge pulse of Y-SUS
To Next Page
Loading...
