Pioneer RX-310 - Page 2

IMPORTANT
The lightning flash with arrowhead, within an
equilateral triangle, is intended to alert the user of the
presence of uninsulated “dangerous voltage” within the
product's enclosure that may be of sufficient magnitude
to constitute a risk of electric shock to person:
READ INSTRUCTIONS — Ail the safety and
operating instructions should be read before the
appliance is operated
RETAIN INSTRUCTIONS — The operating instruc-
tions should be retained for future reference
HEED WARNING — All warnings on the appliance
and in the operating instructions should be
adhered to.
FOLLOW INSTRUCTIONS — All operating and use
instructions should be followed.
WATER AND MOISTURE — The appliance should
not be used near water ~~ for example, near a
bathtub, washbow/i, kitchen sink, laundry tub. in a
wet basement, or near a swimming pool, etc
LOCATION
—
The
appliance
should
be
installed
in
3
stable
location.
WALL OR CEILING MOUNTING — The appliance
should not be mounted to a wall or ceiling
VENTILATION -- The appliance should be situated
so that its location or position does not interfere
with its proper ventilation. For example, the ap-
pliance should not be situated on a bed, sofa. rug,
or similar surface that-may block the ventilation
openings: or, placed in a built-in installation, such
as a bookcase. or cabinet that may impede the
flow of air through the ventilation openings
HEAT — The appliance should be situated away from
heat sources such as radiators, heat registers.
stoves, or other appliances (including amplifiers)
that produce heat.
POWER SOURCES -» The appliance should be
connected te a power supply only of the type
described in the operating instructions or as
marked on the appliance.
POWER-CORD PROTECTION -- Power-supply
cords should be routed so that they are not likely
to be walked on or pinched by items placed upon
or against them, paying particular attention to
cords at plugs, convenience receptacles, and the
point where they exit from the appliance
POLARIZATION = If your purchased product is
provided with a polarized power plug, please read
the following. instructions. This product is
equipped with a polarized alternating current line
RISK
OF
ELECTRIC
SHOCK
DO
NOT
OPEN
CAUTION:
TO
PREVENT
THE
RISK
OF
ELECTRIC
SHOCK.
00
NOT
REMOVE
COVER
{OR
BACK}.
NO
USER-
SERVICEABLE
PARTS
INSIDE.
REFER
SERVIC-
ING
TO
QUALIFIED
SERVICE
PERSONNEL.
SAFETY
INSTRUCTIONS
POWER
LINES
—An
outdoor
antenna
should
be
located
away
from
power
lines.
NONUSE
PERIODS—The
power
cord
of
the
appliance
should
be
unplugged
from
the
outlet
when
left
unused
for
2
tong
period
of
time
OBJECT
AND
LIQUID
ENTRY
—
Care
should
be
taken
so
that
objects
do
not
fail
and
tiquids
are
not
spilled
into
the
enclosure
through
openings
DAMAGE
REQUIRING
SERVICE
—
The
appliance
should
be
serviced
by
2
Pioneer
authorized
ser-
vice
center
or
qualified
service
personnel
when:
@
The
power-supply
cord
or
the
piug
has
been
darnaged:
or
©
Objects
have
falten,
or
liquid
has
been
spilted
into
the
appliance:
or
©
The
appliance
has
been
exposed
to
rain:
or
@
The
appliance
does
not
appear
to
operate
nor-
matiy
or
exhibits
2
marked
change
in
perfor-
mance;
or
@
The
appliance
has
been
dropped:
or
the
enclosure
damaged
SERVICING
—The
user
should
not
attempt
to
service
the
appliance
beyond
that
described
in
the
operating
instructions.
For
all
other
servicing.
contact
the
nearest
Pioneer
authorized
service
center
Power
SERVICE
ENTRANCE
CONDUCTORS.
The
exclamation
point
within
an
equilateral
triangle
+5
intended
to
alert
the
user
of
the
presence
of
important
operating
and
maintenance
{servicing}
instructions
i
the
literature
accompanying
the
appliance.
OUTDOOR
ANTENNA
GROUNDING
--
!f
an
out-
side
antenna
is
coanected
to
the
antenna
termi-
nal,
be
sure
the
antenna
system
is
grounded
so
as
to
provide
some
protection
against
voltage
surges
and
built
up
static
charges
In
the
U.S.A.
section
810
of
the
National
Elec
trical
Code,
ANSI/NFPA
No.
70-1984,
provides
information
with
respect
to
proper
grounding
of
the
mast
and
supporting
structure,
grounding
of
the
lead-in
wire
to
an
antenna
discharge
unit,
size
of
grounding
conductors,
location
of
antenna-
discharge
unit,
connection
to
grounding
elec
trodes,
and
requirements
for
the
grounding
elec
trode.
See
Fig.
A.
a)
Use
No:
10
AWG
(5.3
mm?)
cop-
per,
No.
8
AWG
(8.4
mm?)
alu-
minum,
No.
17
AWG
(1.0
mm?)
copperciad
steel,
bronze
wire,
or
larger
as
ground
wire,
b) Secure antenna lead-in and
ground wires to house with
stand-off insulators spaced from
4 feet (1.22 meters) to 6 feet
(4.83 meters) opart
cc)
Mount
antenna
discharge
unit
as
closely
as
possible
to
where
lead-
in
enters
house
STAND
OFF)
Use
jumper
wire
not
smaller
than
INSULATORS?
No.6
AWG
(13.3
mm*)
copper.
or
the
equivalent.
when
a
sepa-
rate
antenna-grounding
electrode
is
used.
See NEC Section 810-21 (1)
ANTENNA
LEAO (N WIRE
TO EXTERNAL ANTENNA
TERMINALS OF PROOUCT
plug
(a
plug
having
one
blade
wider
than
the
ene
me
other).
This
plug
will
f
:
nk
7
1).
This
plug
will
fit
into
the
power
outlet
only
eaaeng
Mt
anirenin
one
way.
This
isa
safety
feature.
Hyou
are
unable
ce
avice
erance
4
CLAMPS
DISCHARGE
UNIT
¢
to
insert
the
plug
fully
inte
the
outlet.
try
reversing
EQUIPMENT
GaoUNo
the
plug.
f
the
plug
should
still
fail
to
fit,
contact
WIRE
at
your electrician to replace your obsolete outlet
Do not defeat the safety purpose of the polarized
plug POWER SERVICE
CLEANING
~The
appliance
should
be
cleaned
only
GROUNDING
ELECTRODE
SYSTEM
with
@
polishing
cloth
or
a
soft
dry
cloth.
Never
{6
Intevor
meat
wates
ne)
ciean with furniture wax, benzine, insecticides or
(7 OPTIONAL ANTENNA
GROUNOING ELECTROI
ORIVEN 8 FEET (24¢ mi
BONDING — He INTO THE EARTH
other
volatile
quids
since
they
may
corrode
the
JUMPERd
off
IE
REQUIRED
BY
cabinet.
FIGA
8
LOCAL
CODES
SEE.
Uo
NEC
SECTION
810-21
iff
2
<ARBI145>