Pioneer RX-310 - Panel Facilities

CONNECTIONS
Antenna ground
Although grounding is not necessary for reception, it is recom-
mended for protection against damage from lightning if an out-
door FM antenna is used. Grounding is recommended as weil
to help reduce noise and humming.
NOTE:
Never make the ground connection to a gas pipe as sparks could
cause the gas to ignite.
NOTE ABOUT SPEAKER CONNECTIONS
°¢ Speaker systems used should have an impedance of be-
tween 80 and 160.
* Be sure that connections are secure. Check to make sure
that wires do not protrude from their terminals.
® Do not allow the speaker cords to become shorted.
Damage may result to your equipment.
e Do not attempt to simultaneously connect two s of
speakers to a single side (A or 8). When using two
speakers, connect one set to side A and one set to
AC OUTLET SWITCHED 100W MAX
(Multi-voitage model only)
Power supplied through this outlet is turned on and off by
this equipment’s POWER switch. Total electrical power
consumption of connected equipment should not exceed
100 W.
NOTE:
Do not connect appliances with high power consumption such as
heaters, irons, or television sets to the AC OUTLET, in order to
avoid overheating or fire risk.
This can cause this equipment to malfuntion.
To control a unit other than this receiver using the re-
mote control unit
@ In the case of PIONEER equipment marked sR which is
provided with a remote sensor, operate the equipment by
aiming the remote contro! unit at the remote sensor on the
equipment.
@® For equipment marked , without a remote sensor,
operation of the equipment by facing the remote con-
trol unit towards the remote sensor of the cassette deck receiv-
er possible with connection from the CONTROL OUT jack to
the CONTROL IN jack. Use a commercially available cable with
mini-plugs for the connection.
PANEL FACILITIES
we)
our (—
CONTROL O~: “2 —¥@)
our CONTROL CONTROL
yal
gE (7 CO plaver
Cassette deck receiver
ty
Equipment with
the Rj mark.
) ©)
IS
e
a2) 63)
e
©
)
6
<ARB1145>