Pioneer RX-310 - Before Operation; Remote Control Unit

FEATURES
BEFORE OPERATION
High power output
5-band graphic equalizer
System remote contro!
Stereo double cassette tape deck
Synchronized recording start
High-speed copy
Relay play
Auto tape selector
Auto recording level
Quartz PLL synthesizer FM/AM tuner
Up to 24 stations random pre-set
CHECKING ACCESSORY
ITEMS
® Remote control unit
Seem
® FM T-type antenna ° AM loop antenna
BEFORE OPERATION
REMOTE CONTROL UNIT
[1] Remove the cover of the battery compartment on the reverse
side of the remote control unit.
[2} Take out the two size “AAA” [IEC RO3 (UM-4)] dry cell batteries
supplied and load them into the battery compartment, taking
care to follow the markings on the compartment.
{3] Replace the cover of the battery compartment.
Cautions for handling dry cell batteries.
Misusing dry ceil batteries can result in electrolyte leakage or explo-
sions. Bear in mind the following points for getting the most out of
your batteries,
@ When loading the batteries into the battery compartment, make
sure the plus © and minus @ polarities correspond to the mark-
ings on the compartment.
® Even though they may be the same shape, batteries come with
different voltage ratings. Do not mix or use different types of bat-
teries tagether. Use only the same kind of batteries.
@ Do not mix up new batteries and used batteries but replace ail
the batteries at the same time.
e Do not heat up, disassemble or short-circuit batteries or throw
them into a fire.
e Some batteries are rechargeable while others are not. Observe
the cautionary notes on the batteries and use them properly.
TURNTABLE PL-210Z/PL-310Z
INITIAL TURNTABLE SET-UP
1. Check the parts.
= EP adaptor Platter mat Platter
2. Puil dust cover up and off of rear hinges.
(PL-210Z PL-310Z)
3. Turn over platter.
4, Pinch belt on inner rim between thumb and fore-
finger.
5. Slip belt over thumb and pull out, inserting
thumb in hole.
6. Insert forefinger from top of platter and transfer
belt to forefinger.
7. Lower platter >~-*~ spindle.
8. Release belt onto pulley.
Pulley
f @ Rorject
9. Place the platter mat on the platter.
(with “PIONEER” side up)
10. Remove the vinyl band holding the tonearm.
1 1. Remove the tonearm from the arm rest.
jo3
12. Remove the stylus cover.
3
<ARB1145>