Pit Boss 820FB - Page 8

ASSEMBLING & MOUNTING THE CART … CON’T
Step 2 Install Bottom Shelf Assembly:
Models 820FB—Open Shelf Model 820Deluxe—Solid Shelf
 Ins
tall the Bottom Shelf to all four legs.
Using 4 of the 1/4” x #20 x 3/5” scre
ws (AA) and your
Screw driver, hand start then secure the screws firmly to
the leg frame.
Note: Ensure the shelf is installed so the flat surface is facing up

NOW, securely tighten ALL 16 leg screws (AA)
Page 8
Step 3 Install Wheels to Leg Assembly:
 Slide metal wheel onto either leg with the
axle
 Install wa
sher (CC), then hand screw th
e
7/16” x 20 Nut (BB) onto the thread
ed
axle. Use your wrench to tighten.
 Spin each wheel to ensure the whee
ls
turn
freely.
 Carefully lift barrel and attached leg
assembly to the upright position.
Parts Needed:
ASSEMBLING—LID STOPPER
Installation Steps
Step 1 Attach Lid Stopper
 Slip the Lid Stopper front lip into the slot provided
Located at the top of the barrel in the middle.
 Using the screw driver, secure the Lid
Stopper
to the barrel with one 1/4” - #20 x 3/5” (AA) scre
w.
Take care not to over-tighten.
Hardware Required:
Section One: ASSEMBLY INSTRUCTIONS
Screw 1/4”- 20* 3/5” x 1 (AA)