6
2.
Installation:
• Carefully, lift the Hot Plate to expose the feet. Remove the rubber feet
on each of the four corners by turning the screw counterclockwise
until it comes off. Discard the rubber feet with packaging. Replace the
Hot Plate into position on top of the Fire Box.
IMPORTANT: It is advised to read each step entirely before starting assembly on instructions. Do not tighten screws
completely until all screws for that step have been installed, or unless otherwise mentioned.
1.
Parts Required:
1 x Firebox
(#1)
Installation:
• Place a piece of cardboard on the floor and use the foam pieces to
prevent scratching the unit and parts during assembly.
• Unlock the front latch. Open the side shelves to remove the bottom
shelf. Set aside bottom shelf for future installation.
Parts are located throughout the shipping carton, including underneath the griddle. Inspect the unit, parts, and hardware blister
pack after removing from the protective shipping carton. Discard all packaging materials from inside and outside of the griddle
before assembly, then review and inspect all parts by referencing the parts list. If any part is missing or damaged, do not attempt
to assemble. Shipping damage is not covered under warranty. Contact your dealer or Pit Boss® Grills Customer Service for parts:
Monday through Sunday, 4am - 8pm PST (EN/FR/ES).
service@pitboss-grills.com | Toll-Free: 1-877-303-3134 | Toll-Free Fax: 1-877-303-3135
IMPORTANT: To ease installation, using two people is helpful (but not necessary) when assembling this unit.
Tools required for assembly: screwdriver and wrench.
Tools included.
1
5
2
To Next Page
