Pit Boss PBV2A1 - Mounting Power Cord Bracket; Mounting Dampers to Upper Cabinet Assembly; Mounting Back Handle

12
11
7.
MOUNTING POWER CORD BRACKET
ONTO LEFT LEG PANEL
Parts Required:
1 x Support Panel (#20)
1 x Power Cord Bracket (#26)
2 x #10-24*1/2”Screw (#C)
Installation:
• Mount Power Cord Bracket (#26) onto the
left side of Support Panel (#20) using 2 x
#10-24*1/2”Screw (#C) as Fig.7.1 & Fig.7.2
shown.
Fig.7.1
8.
MOUNTING DAMPERS TO THE UPPER
SMOKER CABINET ASSEMBLY
Parts Required:
1 x Upper Smoker Cabinet Assembly (#2)
2 x Damper (#1)
2 x #10-24*1/2”Screw (#C)
2 x #10-24 Nut (#D)
2 x M5 Spring Washer (#E)
Installation:
• Mount Dampers (#1) to the Upper Smoker
Cabinet Assembly (#2) using 2 x
#10-24*1/2”Screws (#C), 2 x M5 Spring
Washer (#E)and 2 x #10-24 Nut (#D) as
Fig.8 shown.
9.
MOUNTING BACK HANDLE TO THE
UPPER SMOKER CABINET ASSEMBLY
Parts Required:
1 x Upper Smoker Cabinet Assembly (#2)
1 x Back Handle (#3)
4 x 1/4-20*5/8”(#A)
Installation:
• Mount Back Handle (#3)to the Upper
Smoker Cabinet Assembly (#2) using 4 x
1/4-20*5/8”(#A) as Fig.9 shown.
Fig.9
Fig.8
Fig.7.2
#26
----------------
Note: Turn the Lower Smoker Cabinet
with Control Panel and Legs Assembly
Right Side Up as Fig.7.2 shown and
tighten all screws now.
#1
-------
#3
-------------