Pit Boss PBV2A1 - Attaching Door Assembly; Inserting Heat Indicator into Door Assembly; Mounting Door Latch Assembly

14
13
13.
MOUNTING DOOR GREASE SHIELD TO
THE DOOR ASSEMBLY
Parts Required:
1 x Door Grease Shield (#25)
1 X Door Assembly (#8)
5 x #8-32 Self-tapping Screw (#F)
• Attach the Door Grease Shield (#25) to
the Door Assembly (#8) using 5 x #8-32
Self-tapping Screw (#F) as Fig.13 shown.
Fig.13
14.
ATTACHING DOOR ASSEMBLY INTO
THE UPPER SMOKER CABINET
ASSEMBLY
Parts Required:
1 x Door Assembly (#7)
1 X Upper Smoker Cabinet Assembly (#2)
Installation:
•Attach Door Assembly (#7)into the Upper
Smoker Cabinet Assembly(#2)as Fig.14
shown.
15.
INSERTING HEAT INDICATOR INTO
THE DOOR ASSEMBLY
Parts Required:
1 x Door Assembly (#7)
1 X Heat Indicator (#6)
Note: The Heat Indicator is supplied with
one fiber washer and one wing nut.
Installation:
•Insert Heat Indicator (#6)probe through the
mounting hole in the front of the Door
Assembly(#7). From the inside of the door,
place fiber washer and wing nut onto the
mounting thread pole and tighten by hand as
Fig.15 shown..
Fig.15
Fig.14
Installation:
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
#25
#6
---------