Deleting a Job
Deleting an existing job requires Supervisor level access.
1. Tap the Setup button on the main screen. The Enter Access Code: field displays over the
inserter model and the keypad appears on the touchscreen display.
2. Using the keypad, type the Supervisor code (71) and tap the Enter key. The Enter Access
Code: field counts up or down to display the password code entered.
3. Tap the >> button to accept the code and advance to the job selection.
4. Tap the + and – buttons to display the job you wish to delete.
5. Tap the X button to delete the job. The display shows “Do you want to delete this application?”
6. Tap the checkmark.
7. Tap the X button to delete the job. The display briefly shows “Deleting Job” as the job is erased.
8. Tap the Setup button to exit job setup mode.
Product Overview
Pitney Bowes Relay™ 2500, 3500, 4500 User Guide December, 2018 Page 66 of 174
To Next Page
Loading...
