Adding Sealer Solution
1. When the Add sealing solution icon flashes, add E-Z Seal® Solution.
Icon Description
Add sealing solution
2. Open the sealer bottle cover hinge located at the rear, right side of the inserter and remove the
bottle.
3. Fill the bottle with the solution to the level indicated.
4. Place the sealer bottle in position in the inserter and close the cover.
NOTE: If the sealer unit was completely empty, allow time for the fresh solution to soak through the
sealer before resuming operation. This helps ensure a good seal.
NOTE: We recommend Pitney Bowes E-Z Seal to minimize algae growth and scale build-up.
Running a Job
Pitney Bowes Relay™ 2500, 3500, 4500 User Guide December, 2018 Page 90 of 174
To Next Page
Loading...
