17
In MANUAL mode:
•The MC's LCD may be switched off (only the
backlight is clearly visible) or you may continue
to see the indication that was present at the
time of transition from AUTO to MAN.
•No PIN CODE is required to activate the
pump; the pump starts when the dispenser
nozzle is removed from its lodging and stops
when it is put back (naturally this is in the event
that the "nozzle contact" function is used).
•The amount dispensed is not shown in any
way.
Before accessing the electrical parts, be sure that you have disconnected all of
the general switches that power the device.
WARNING
All the MC BOX functions are controlled by the MC control system.
The MC system can nevertheless be disengaged for any startup or maintenance
activities requiring repeated pump starting.
In these case, it is often convenient to simplify pump startup by not having to enter any
code and record any dispensing data.
To do this, a JUMPER has been fitted on the card that permits switching from
AUTOMATIC mode (code request to access dispensing) to MANUAL mode (no code
request).
I.3DISENGAGING THE “MC” SYSTEM
The jumper is only accessible by opening the front panel and is positioned as
shown in the photo.
In this operating mode, MC does not record any data relating to performed
dispensing operations.
Before accessing this jumper, the voltage must be removed.
WARNING
WITHOUT
JUMPER
JUMPER
IN POSIT.
AUTO
EN
To Next Page
Loading...
