GTECHNICAL SPECIFICATIONS
10
The performance of the MC control system is detailed in the M0187 manual supplied
together with the MC BOX.
Implementation of a fluid dispensing system, intended for private use, not subject to
special regulations (e.g. ATEX) for potentially explosive environments.
Mainly influenced by the pulsation type used.
For further details, please refer to the specific user manual for the pulsation type used.
The MC BOX can be installed outdoors. Nevertheless, it is advisable to locate it under
the shelter of a roof to ensure the dispenser's longevity and provide greater comfort
during refueling in the event of bad weather.
The installation of the dispenser must be carried out by skilled personnel and performed
according to the instructions provided in this chapter.
The power connections must be workmanlike performed by skilled personnel, in strict
compliance with the laws applicable in the country of installation and with the
instructions on the wiring diagrams in this manual.
G.2CONTROL SYSTEM PERFORMANCE
G.1PERMITTED USES
G.3METERING PRECISION
H.1GENERAL
H.2ELECTRICAL CONNECTIONS
G.4ABSORBED POWER
HINSTALLATION
See table, paragraph E.1.
The maximum acceptable variations from the electrical parameters are:
• Voltage +/-10 % for AC versions
• Voltage +/-15 % for battery-operated DC versions
• Frequency +/-1% (+/-2% for short periods) (for AC versions)
The electronic control system -MC- ensures the dispenser can only be used by
authorised personnel.
All the data relating to each dispensing operation are stored and can be transferred
to a PC (optional).
F.1CONTROL SYSTEM
EN
To Next Page
Loading...