19
The pump will start (if previously enabled) just as soon as the control lever is moved
to ON position, while it switches off as soon as the control lever is moved to
OFF position.
No further manual operation is required to start or stop the pump.
In the case of the simplest configuration (no optional data required), the fuel dispensing
procedure is the following:
•Insert PIN CODE
(or apply the electronic key)
If the MC recognises the activated PIN
(or key), a “GOOD MORNING MANAGER /
USER” message is displayed and the
pump enabled.
For details on dispensing options, please
refer to the M0187 manual.
L.1FUEL DISPENSING
Such enabling does not result in immediate pump startup.
The pump is in fact controlled by a switch (positioned in the nozzle seat)
operated by the user.
WARNING
Fuel MUST ONLY be dispensed under the careful control of the User.
WARNING
The configuration of the MC system permits requiring the User to enter further optional
data (vehicle licence plate, mileage, quantity to be dispensed).
For details, see the MC control system manual.
In the event that these options are not set, MC will recognise an activated PIN CODE
and, once the nozzle contact (if applicable) has been closed, the pump is enabled,
allowing it to dispense
EN
To Next Page
Loading...
