Piusi PW-LAN - Package Contents;Pre-Inspection; Machine and Manufacturer Identification

26 M0270 EN
EN
4.4 PACKAGE CONTENTS/PRE-INSPECTION
FOREWORD
To open the packaging, use a pair of scissors or a cutter, being
careful not to damage the dispensing system or its components.
NOTES In the event that one or more of the components de-
scribed below are missing from inside the package,
please contact Piusi inc technical support.
WARNING Check that the data on the plate correspond to the
desired specications. In the event of any anomaly,
contact the supplier immediately, indicating the nature
of the defects. Do not use equipment which you suspect
might not be safe.
4.5 MACHINE AND MANUFACTURER IDENTIFICATION
FOREWORD
PW-LAN comes with an identication plate; this is
attached externally and contains the following in-
formation:
model
- lot number / Production year;
- technical data;
ATTENTION
Before installing, always make sure the type of
dispensing system is correct and suitable for the
available power supply (Voltage/Frequency.)
Make sure that the plate does not deteriorate or be-
come detached over time.
NOTE
Should this situation arise, please contact our
support department and arrange to have the
damaged or missing plates sent back and replaced
where necessary.
The plates are the following:
1 - Front plate 3 - CE mark
2 - Technical Data Plate 4 - CE plate /Lot/Year
WARNING
disconnect
before
servicing
100-240V
50-60Hz/ 15W I P54
operating
temperature
-20/+50°C
KIT LAN CONNECTION
PW - LAN
MADE IN ITALY
1
2
3 4