15
5.9 Memory Card
Parameters settings and setpoints values can be easily and
quickly copied using the Memory Card. The controller must be
switched off before entering the Card. Please check also entry
direction. Switching the controller on, display 1 visualizes
and display 2 visualizes . (Only if the values
stored on Memory Card are correct).
Press Display Do
1
visualize ,
visualize .
Select if
values stored on
MemoryCard must be
loaded on the
controller.
Select
to
keep the parameters of
the controller
unchanged.
2
Press
The controller loads the
values and restarts.
Updating Memory Card.
To update values of Memory Card,
follow the above operations selecting
on small display so that
values of Card are not loaded on the
controller
. Enter configuration mode
and modify at least one parameter.
Quitting the configuration mode, the
new values are automatically saved.
2
If the controller does not visualize
, this means that the
Card does not contain any data, but it is possible to copy and
update them.
To Next Page
Loading...
Need help?
General
