13
Gigabit SFP Slots
1000BASE-SX/LX mini-GBIC slot, SFP (Small Factor Pluggable) transceiver
module: From 550 meters (multi-mode ber) to 10/20/30/40/50/60/70/120 kilo-
meters (single-mode ber).
DIP Switch
The DIP switch that is located on the front panel of the FGSD-1022VHP 802.3at
PoE+ Switch provides “Standard”, “VLAN” and “Extend” mode selection;
the “Extend” mode features 30-watt PoE transmit distance of 250m at speed
of 10Mbps. For VLAN isolation, the FGSW-1822VHP or FGSW-2622VHP provides
“Standard” and “VLAN” mode selection; the “VLAN” mode is for IP surveillance
application. The detailed descriptions are shown in the following table.
Model FGSD-1022VHP FGSW-1822VHP FGSW-2622VHP
DIP Switch
Mode
Function
Standard
(default)
This mode makes the 802.3at PoE+ Switch operate as a general
switch and all PoE ports operate at 10/100Mbps auto-negotiation.
VLAN
1. Port 1 to port
8 will isolate
respectively.
2. Port 1 to port
8 can only
communicate with
port 9 and port 10
(uplink port).
1. Port 1 to port
16 will isolate
respectively.
2. Port 1 to port
16 can only
communicate with
port 17 and port 18
(uplink port).
1. Port 1 to port
24 will isolate
respectively.
2. Port 1 to port
24 can only
communicate with
port 25 and port 26
(uplink port).
Extend
With
VLAN
Isolution
1. Port 1 to port
8 will isolate
respectively.
2. Port 1 to port
8 can only
communicate with
port 9 and port 10
(uplink port).
3. 30-watt PoE
transmit distance
of 250m at speed
of 10Mbps.
Extend mode not
supported.
Extend mode not
supported.
Table 2-1: FGSD/FGSW 802.3at PoE+ Switch DIP Switch Description
To Next Page