2.2 Install the Converter
This section describes how to install your Managed Media Converter and make connections to the Managed Media
Converter. Please read the following topics and perform the procedures in the order being presented. The hardware
installation of Managed Media Converter do not need software configuration. To install your Managed Media Converter on
a desktop or shelf, simply complete the following steps.
2.2.1 Stand-alone Installation
To install a Managed Media Converter stand-alone, on a desktop or shelf, simply complete the following steps:
Step 1: Turn off the power of the device/station in a network to which the Managed Media Converter will be attached.
Step 2: Ensure that there is no activity in the network.
Step 3: Attach fiber cable from the Managed Media Converter to the fiber network. TX, RX must be paired at both ends.
Step 4: Connect the 5V DC power adapter to the Managed Media Converter and verify that the Power LED lights up.
Step 5: Turn on the power of the device/station; the PWR LEDs should light when all cables are attached.
-8-
To Next Page
Loading...
Need help?
General
