Planet IHD-200PT - Page 24

HDMI / Video Wall over IP with PoE
IHD-200PT / IHD-200PR
24
Select "Use the following IP address".
IP address: You have to set the same network segment between your PC’s IP
and the transmitter / receiver.
Ex: If the transmitter’s IP is 169.254.0.157, then you should set 169.254.0.xxx
where xxx can be any number between 2 and 253. (same as receiver)
Subnet mask: Enter 255.255.0.0.
6. If necessary, you may enter “Advanced” to add more that one IP address.
Generally, except for updating firmware, you only need to set the same network
segment between your PC’s IP and the transmitter to configure all the receivers.