HDMI / Video Wall over IP with PoE
IHD-200PT / IHD-200PR
38
Reset EDID to Default Value: User can copy the EDID from this Rx to other Rxs
with the same ID. (the same group)
4.4.2. Serial over IP
Enable Serial over IP: If user unchecks this item, then serial 2 can’t be used.
Operation Mode:
Type 1 and Type 1 guest modes have to do other commands.
Type 2 (extender transmit) and Type 2 guest mode use telnet through port 6752.
(Usually, the API command is for our engineer to use, but not for end users.)
Baudrate Setting: User can set baudrate here for the unit.
To Next Page
Loading...
