14
Step 5. Connect a PC to a computer port of the KVM, for example port 1.
DC 12V
8 7 6 5 4 3 2 1
KVM-210-08M Rear Panel
Step 6. Attach the power supply to the KVM unit and plug the other end into
an electrical receptacle. Now you will see the LED for Port 1 light up.
Switch on your monitor from the Port Select button.
KVM switch supports hot plug function, but please take neces-
sary measures to avoid any occurrence of occasional short
circuits caused by the pin of KVM connection cable contacts
touching the hex screws.
To Next Page
Loading...
Need help?
General