14
4. TROUBLESHOOTING
This chapter contains information to help you solve issues. If Desktop
Fast Ethernet Switch is not functioning properly, make sure the Desktop
Fast Ethernet Switch was set up according to instructions in this
manual.
Some stations cannot talk to other stations located on the other
port Solution:
The address table may contain older information than of the address
table of that node. Please power down to refresh the address
information.
Performance is bad Solution:
Check the speed duplex mode of the partner device. If the partner is
set to half duplex, then the performance will be poor.
Why the Switch doesn’t connect to the network Solution:
Check the LNK/ACT LED on the Switch
Try another port on the Switch
Make sure the cable is installed properly
Make sure the cable is the right type
Turn off the power. After a while, turn on power again
To Next Page
Loading...
Need help?
General
