User Manual of WDAP-C3000AX, WDAP-3000AX, WDAP-W3000AX
- 89 -
4.4.6 Wi-Fi Advanced
This page allows the user to define advanced setting of Wi-Fi.
Figure 4-58: Wi-Fi Advanced
2.4GHz Maximum Associated Clients
5GHz Maximum Associated Clients
The coverage threshold is to limit the weak signal of clients
occupying session. The default is -95dBm
The coverage threshold is to limit the weak signal of clients
occupying session. The default is -95dBm
The range of transmit power is Max (100%), Efficient (75%),
Enhanced (50%), Standard (25%) or Min (15%). In case of
shortening the distance and the coverage of the wireless network,
input a smaller value to reduce the radio transmission power
The range of transmit power is Max (100%), Efficient (75%),
Enhanced (50%), Standard (25%) or Min (15%). In case of
shortening the distance and the coverage of the wireless network,
input a smaller value to reduce the radio transmission power
Set the function as enable or disable
Set the function as enable or disable
Enable or Disable RTS/CTS protocol. It can be used in the
following scenarios and used by Stations or Wireless AP.
1) When medium is too noisy or lots of interferences are present. If
the AP/Station cannot get a chance to send a packet, the
RTS/CTS mechanism can be initiated to get the packet sent.
2) In mixed mode, the hidden node problem can be avoided.
The default value is 2347
To Next Page
Loading...
Need help?
General
