b. The Channel Settings Screen
The setup options are listed below:
Object Description
2.4 G
This indicates the 'Wireless Mode' selected in the previous Network
Settings screen. From the drop-down list, select the appropriate
hannels available
for each region, see the Country Channel List.
r
Hz
code for your region. For more information on the c
Channel: Leave at its default value, o
Channel
you select Enable 40 MHz Bandwidth', choose a channel with
minima
Leave at its default value, or if interference is a problem on your
network, choose a channel which experiences less interference. If
l interference on the four channels adjacent to your selected
channel.
Enable 40 MHz
Bandwidth
ption to increase the bandwidth available for your
nly supported by IEEE 802.11n devices. If a
efault level.
Select this o
wireless connection. This function works by incorporating the
bandwidth available on the four channels adjacent to your selected
channel. This option is o
computer or device connected to the AP does not support this
function, bandwidth is reduced to its d
51
To Next Page
Loading...
