Copyright Planika Sp. z o.o. www.planikafires.com 3
I. Safety
Fire Line Automatic is a decorative appliance with real flames that is why in order to use the
device properly and safely and in order to keep the warranty, the following safety rules
should be observed. Fire Line Automatic is not a heating device.
• The device should be installed according to the rules given in the installation manual.
• While working, the device emits heat, water vapour and carbon dioxide, therefore it is
necessary to provide proper cubic capacity of the room and proper ventilation of the interior.
• During the device starting-up sequence, the characteristic smell of the liquid used in the device
or the recommended FANOLA® liquid may be perceptible.
• It is obligatory to have a carbon-dioxide or dry chemical extinguisher placed nearby the device.
• The device that is switched on must not be moved. Wait for complete fuel burn-out, disconnect
the power supply and cool down the elements before moving the device.
• The device should not be left without adult supervision.
• Prevent handling of the device by persons not trained.
• Do not attempt to make changes or repairs to the construction of the device on your own.
Repairs can be made only by a person trained to service the device.
• Do not pour FANOLA liquid to a furnace, as it may cause damage of the device and cause fire.
Pouring FANOLA liquid to a burning furnace may cause a sudden ignition and can cause fire,
burns and a risk to life.
• Do not heat the FANOLA liquid before starting-up the device.
• Do not start up the device if the FANOLA liquid spilled out from the container.
• Do not cover the working device as it may cause fire.
• Keep the device and fuel away from children, pets and unauthorized persons.
• FANOLA liquid is not suitable for consumption. Avoid contact with skin and eyes.
• Do not operate by the filler when the device is running.
• Do not tamper with the elements inside the furnace body at the risk of burns, damage to the
device or fire.
• Some elements of the device heat up to high temperatures. Do not touch the area of the
furnace of the device as it may cause burns.
• Do not place any decorative elements on the burner’s surface.
• WARNING! The glowing coil temperature heats up to 1300 °C. Touching the device while it is
turned on may cause burns.
• WARNING! Prior to moving the appliance burn the fuel out and move the appliance slowly,
in the horizontal position, avoiding shaking. There is always some fuel left inside the device
and if spilled the sensors might get wet. If that happens the appliance will not work until the
liquid evaporates.
• WARNING! The first run can be made only after proper installation of the device and reading
the manual instructions!
To Next Page
Loading...
