Copyright Planika Sp. z o.o. www.planikafires.com 8
ATTENTION!
The appliance will automatically stop working when:
the fuel burns out (NO FUEL message),
the temperature of the appliance is too high, (COOLING THE DEVICE TEMPERATURE TOO HIGH
message)
INFO! To avoid abrupt switching off when the temperature approaches the critical one, the flame size
will be diminished to 50% and will restrict the ability to increase the flame size – when you try to
increase the flame size, the message will appear
If the temperature of the device still increases, the device will switch off. When the temperature
decreases to the safe one, flame size can be increased again.
the device is moved or it senses seismic shocks (COOLING THE DEVICE. DEVICE HIT message)
the device is tilted (COOLING THE DEVICE. DEVICE TILTED message)
the allowed level of carbon dioxide is exceeded in the room (COOLING THE DEVICE CO
2
LEVEL
TOO HIGH message)
any occurrence takes place that evokes ERROR message
Information and warning alerts
button is
flashing
The device is connected to
the mains, but remains
dormant.
To start operating the device, press the red button on the
control panel. In this mode, the device does not respond
to commands sent from the remote control, the
configured device nor buttons on the control panel.
READY
The device is connected to
the mains and ready to start.
immediately start the device.
NO FUEL
The fuel reservoir is empty.
Refill the fuel following the description in point
instruction manual.
RESERVOIR
FULL CLOSE
THE LID
The fuel reservoir is full. Close the filler bolt. You can start the device now.
FILL WITH
FUEL
The filler bolt is open.
You can refill the fuel or close the bolt and start the
device.
COOLING
THE DEVICE
restart of the hot device is
active.
Wait until the device cools down. The message will
change to
READY
.
To Next Page
Loading...
