To Next Page
M
Michelle HollowaySep 9, 2025
Why is Planmeca Dental equipment milling not completing on the facial surface of an anterior tooth?
- CcraigmyersSep 9, 2025
If milling is not completing on the facial surface of an anterior tooth with your Planmeca Dental equipment, and the restoration is longer than normal, change the block selection to Multi Block on the Planmeca PlanCAD Easy, ensuring you select the same block size. You can then insert a standard Empress LT or HT block of the same size. The milling unit makes multiple passes on Multi blocks, while other materials use a single pass.
General
